3033 HPLC calibration standard serotonin

Calibration Standard

Order no.: 3033
  • Serotonin
Serotonin in Serum/Plasma/Whole Blood - HPLC


Calibration Standard for analysis of serotonin in serum/plasma/whole blood, primary standard solution

This aqueous calibration standard (order no. 3033) from Chromsystems is injected directly into the HPLC system without sample preparation. While following the instructions the calibrator should be measured in the same manner as a patient specimen.
An alternative is the lyophilised calibrator (order no. 3009) that is based on human plasma and should be used according to the instruction manual.

Technical Data

Method of Analysis



10 ml




Please note: Concentration values shown here are typical. For specific concentration values please refer to the instruction manual.

SubstanceUnitAqueous Calibration Standard 
10 ml (Order no. 3033)
Plasma Calibration Standard 
5 x 1 ml, lyoph. (Best.-Nr. 3009)
Serotonin µg/l


Plasma Calibration Standard (order no. 3009)

Carefully remove the metal seal and rubber stopper from the vials. Add exactly 1.0 ml of distilled water into each vial. Return the stopper and incubate for 10 to 15 minutes at room temperature. Swirl the vials to dissolve the contents until homogeneity.

Storage conditions

Plasma Calibration Standard (order no. 3009)

Stored at +2 to +8 °C and unopened, the lyophilised calibrator is stable until the expiry date specified on the vial labels. The reconstituted calibrator can be stored up to 2 days tightly capped at +2 to +8 C. If the calibrator cannot be used within this period, it should be aliquoted and stored frozen below -18 °C (up to 3 months). For more details about storage conditions please check your instruction manual.